General information
Category:
Reports & Report designer
Mark,
The general rule is that you blank all or part of the EXPR field in the
first record of the FRX file, leaving all lines that set Portrait or
Landscape, but deleting the lines that relate to SPECIFIC printers.
You then also blank out the TAG and TAG2 fields of that same first
record.
This gives you an FRX which will enable your users to print to any
printer, not just the printers you developed on.
Michel.
================ Your original message follows =====================
>Thanks, I'll give it a try and see what happens.
>
>Mark
>
>>Ok, leave that part in! Since you are doing it in a program anyway, go ahead and be creative! :-)
>>
>>Seriously though, procede with this stuff carefully, I haven't had need to test this stuff yet, I just noticed that no one had responded to your post, and thought I could pass along what "book" learning I had.
>>
>>>Looking at the contents of these fields I could agree with tag and tag2, but expr contains information such as orientation, I would be hesitant to remove that since most of the reports print landscape.
>>>
>>>Mark
>>>
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only