You should add your job offer in the classified. It's free.
>I am looking for a FoxPro Developer/Consultant that can assist in converting a Clipper Summer 87/Clip 5.x application to FoxPro 2.6 for DOS. The application has no user interface in the released mode and a small user interface in debug mode. The device driver is for controlling a stepper motor controller board through the parallel port via a command interface.
>
>Plese contact Peter Santrach at 1-888-345-8232 if you are interested in this project.
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only