Information générale
Catégorie:
Codage, syntaxe et commandes
Titre:
Operator/Operand Type Mismatch on 'Select 0'
and if I replace "0" with the name of an open table - the same complaint! Yet as soon as I run the same command from the command window - no problemo...
Fortunately it only happens in one place in the code - the first line of a procedure. So it must reflect some bizarre memory problem presumably caused by something I've just run. Nothing obvious leaping out at me yet.
Anyone ever seen anything like it?
Harry
Suivant
Répondre
Voir le fil de ce thread
Voir le fil de ce thread à partir de ce message seulement
Voir tous les messages de ce thread
Voir tous les messages de ce thread à partir de ce message seulement