That same thing happened to me.

I discovered that I had to delete the COMPRESS and NETSETUP directories that the setup wizard generates. Then I delete the DISTRIB that's in the VFP directory. Be careful there's another one called DISTRIB.SRC you must NOT Touch this.

After deleting the above directories I re-run the setup wizard and all went fine. Hope this helps.

Luis


>There are a lot of files you need to put in your distrib directory for it to work.. Have a look at the dynazip web site they will give you a list of files to install..
>
>Regards
>Fred
>
>>Yeah,
>>
>>I select the DZZip control from the controls toolbar and place it on the form.
>>
>>How do you use DZ without the ActiveX control?
>>
>>TIA
>>>I use DZ but not the OCX. I place a copy of the DZIP32.DLL, DUNZIP32.DLL, DZ_EZ32.DLL and DZPROG32.EXE in my folder where I run the setup wizard from. All of these files are installed into the APP folder. Are you really trying to install the OCX [ActiveX control]?
>>>
>>>>Ok, I know this is a no-brainer for someone... I'm using DynaZip in my app and I need to register the ActiveX controls when the app is installed. I know this is done in the setup wizard, but... when I check the ActiveX checkbox for the DynaZip files ( a few dll's and an exe ), I get an error when I run the resulting setup.exe file.
>>>>
>>>>The error occurs right after selecting the install directory and it says:
>>>>
>>>>-------------------------------
>>>>Setup error 827
>>>>Object 11
>>>>
>>>>Your Setup files may be damaged. Try restarting
>>>>the Setup program from where you oiginally ran it.
>>>>-------------------------------
>>>>
>>>>Any ideas?
>>>>
>>>>TIA