General information
Category:
Reports & Report designer
Title:
Label ejecting on tractor fed labels
Help on this problem please..
I am doing maintenance on a VFP 5.0 program that prints labels. One of the available labels is an Avery 4146. Whenever the user prints the labels, it prints 7 and then ejects 1/2" to the top of the next supposed page. The labels are 1 1/2" high so 7 of them make 10 1/2", so I assume the printer thinks this is an 11 inch piece of paper. I hooked up an Okidata 321 and tried and sure enough after 7 labels it kicks ahead 1/2". I went into printer set up to try and change paper size but to no avail.
Thanks for the help.
Bob
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only