General information
Category:
Reports & Report designer
>>>>At the end of the report, I want to print a label if a field in the report has ever been 0.
>>>>
>>>>Any ideas?
>>>>
>>>>Thanks,
>>>>
>>>>Michelle
>>>
>>>Why not determine the status of this condition before running the report, storing the result in a variable, then (not) print the label based on this condition? You can operate on the table/cursor before running the report to establish the condition of the field.
>>>
>>>Bill
>>
>>That would be easy, IF this wasn't SBT. Pre-report processing means wading through miles of spaghetti code. I'm hoping this can be done with report variables.
>>
>>Thanks,
>>
>>Michelle
>
>Gotcha. Never done this specifically with report variables, but it seems like something should be able to be worked out with them.
>
>Bill
Nick had a good idea. Unfortunately, I got a lot to do before I can test it out.
Thanks,
Michelle
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only