General information
Category:
Forms & Form designer
>Check to see that your pageframe, page, or object enabled property is not being set to ".t.", if it is, then I believe your object enabled property is getting replaced with the ".t."
>
>I am not 100% sure but for example, if pageframe1.page1.yourobject.enabled property is = Ok2Edit (where Ok2Edit may be .t. or .f.)
> and at some point in your code sets pageframe1.enabled=.t.
>then I believe that will replace your object's enabled property with .t.
I have checked that also, infact I tried to use the same logic on
a simple form with no pageframes, but the controls are not getting
any effect, whatever is at the start of software it remains same.
(I have set the enable property to =doedit). Pls Advs
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only