General information
Category:
Reports & Report designer
>Below is the SQL of the view I am using for a report:
>SELECT Pathis.patnumber AS caseid,;
> ALLTRIM(Pathis.lastname)+", "+SUBSTR(Pathis.firstname,1,1) AS patient,;
> Blank.describe AS staffmember, Pathis.comptime AS caseseconds,;
> Pathis.in_or_out AS inoutstatus, Patproc.dcode AS proccode,;
> Patproc.procname AS procname, Pathis.time AS starttime, Pathis.endtime,;
> Pathis.or_date AS ordate, Pathis.d1 AS surgeon;
> FROM doc!blank INNER JOIN doc!pathis;
> INNER JOIN doc!patproc ;
> ON Pathis.control = Patproc.patnumber ;
> ON Blank.refdbf = Pathis.patnumber;
> WHERE Pathis.or_date BETWEEN ?mq_start AND ?mq_end;
> AND Blank.type = "S";
> ORDER BY Blank.describe, Pathis.patnumber, Patproc.dcode
>
>The report has two grouping: StaffMember and CaseID
>Data looks something like this:
> STAFFMEMBER
> CASEID CASEINFO
> proc1 procdesc1
> proc2 procdesc2
> Total Case: ### Total Procedures ###
>
>My problem is I can't figure out how to get the variables setup right for getting the total number of cases. For example, the first group is for brenda, there are a total of 3 cases, 2 cases have 2 procedures listed in the detail line, and 1 has 1 procedure listed in the detail line.
>So I want the Group Footer to reflect Total Cases: 3 Procs: 5
>
>Thanks
>Kirk
>kkelly@cqisol.com
Kirk,
In your footer band for the group put the count of caseid. You may have put caseid in you order line toget a good count.
Tom Molloy
PS If you use & lt and & gt, you will get < and >.
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only