Not just skip over it, it just goes straight to the next procedure.
The part it won't trace is in the main body of the program. The
trace just goes to the very first procedure below it and just
stays there while tracing (the part that says PROCEDURE MyProcedure1
for example). I can do STEPs, but it just stays on that line and
to any other part that is not part of the main body. HTH
Thanks
>>I'm using VFP6. We have this large program (over 3000 lines)
>>that prints reports.
>>
>>When ever I try to run it with the debugger on, it just won't
>>trace through a section of it. I tried using set step on in
>>the part I needed to trace to no avail. All the brake points
>>at that part won't do it either.
>>
>>I'ts really very frustrating to not be able to trace that
>>part since that is where the bug in my program is.
>>
>>I already tried to brake down the program to smaller parts
>>and even that didn't work.
>>
>>Any help will be greatly appreciated. TIA.
>
>Does it just skip over it?
Speak using soft and sweet words in case you have to eat them later.