We are primarily working in 5.0 but we have a lot of
Foxpro 2.6 code and we have it running in NT4.0. One problem that has cropped up --
report form xxxx to print
if we do not use the prompt command - we get a printer not ready error. This only happens in NT and 2.6 (5.0 is fine and 2.6 in windows 3.1 is fine)
If we use the prompt and just say OK not changing anything - it prints fine.
I tried putting a wait window timeout 2 prior to print to see if it was a timeing problem -- did not help.
I can ask for the contents of a memo field to print - and it prints fine - then I go back and try the report - same problem.
.
Any suggestions?
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only