General information
Category:
Coding, syntax & commands
Don't worry about the wide screen. That was because of a HTML tag that I used.
The if depends on your data type. It would either be
IF thisform.combo1.value <> 0
OR
IF thisform.combo1.value <> "0"
>Almost there. (Thanks for the pat on the back for psuedocode.)
>
>The misunderstanding was my fault.
>I need it to say:
>IF combo1 has anyvalue other than 0 & ...
>do this function
>ENDIF
>
>Thanks again.
>
>By the way Evan, do you remember me complaining that youre mail crashed
>my system? Well, it almost just happened again. It's really wierd. If I
>receive mail (on UT & so far only from you) the page in my mail frame
>is oversized (I can see only your picture and half of your name in my
>"To" section on the top of the page). When I see this, I know that all
>I have to do to crash my system is grab the scrollbar and scroll
>down . . . CRASH. The Microsoft mouse scroller doesn't have a problem
>with it. In addition, when the UT refreshed posted messages, the page
>reverted back to its proper size.
>
>Do you think that this is something I need to report?
>
>JD
>
>>It doesn't matter how each control got its value. You can do something like this. Note that your pseudo code was right.
>>
>>IF thisform.combo1.value = "Greece" AND thisform.combo2.value = "3.1432" AND thisform.combo3.value = "Euclid"
>> nAnswer = JimmyDitta("somevaluepassed")
>>ENDIF
>>
>>>I found my problem. What i need to say is :
>>>
>>>IF combo1 has a value & combo2 has a value & combo3 has a value
>>>do this function
>>>ENDIF
>>>
>>>combo1 has hand entered values
>>>combo2 has an array in the init
>>>combo3 has hand entered values
>>>
>>>I'm not sure how to state it. Could you maybe give me a hint?
>>>
>>>
>>>
>>>>Hi Jimmy. Make the debugger your friend, it is very useful not only for debugging but for testing out how VFP does things and for getting a grip the scoping of variables.
>>>>
>>>>For info on using the debugger see the VFP help and fox.wikis.com
>>>>
>>>>>Debugger (which i'm not really famaliar with) only gives locals for the spinner as my entire database. I'm guessing it's trying to give me a clue?
>>>>>I'm also guessing that you're saying that the problem is in some of my function code somewhere and debugger is going to help me find it?
>>>>>
>>>>>>>If the value in Spinner1 is chosen first, then the value of other controls, the value in Spinner1 interactively changes back to zero. what could be causing this?
>>>>>>
>>>>>>Put SET STEP ON in the lost focus of spinner. Then step through the code and monitor the value of the spinner. Also, in the debugger you can set a breakpoint on the value of thisform.spinner1.value and the code will halt when the value changes.
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only