General information
Category:
Reports & Report designer
Title:
Producing labels in VFP5
I have a label report that uses a 4" x 3 1/3" label.
The report contains 5 fields as below:
cLine1 is a 36 car. courier 10 line
cLine2 is a 36 car. courier 10 line
cLine3 is a 36 car. courier 10 line
cLine4 is a 175 car. arial 12 line although in a lot of cases it is shorter than the 175 caracters reserved for it.
cPersonal is a 240 car. arial 12 line although in a lot of cases it is shorter than the 240 caracters reserved for it.
line1: cLine1;
line2: cLine2;
line3: cLine3;
line4: alltrim(cLine4);
line5: reserved for wrap of cLine4
line6: reserved for wrap of cLine4
line7: reserved for wrap of cLine4
line8: reserved for wrap of cLine4
line9: alltrim(cPersonal);
line10: reserved for wrap of cPersonal
line11: reserved for wrap of cPersonal
line12: reserved for wrap of cPersonal
line13: reserved for wrap of cPersonal
line14: reserved for wrap of cPersonal
line15: reserved for wrap of cPersonal
I would like alltrim(cPersonal) to place itself right after alltrim(cLine4) so that if alltrim(cLine4) uses only line4 and line5, then alltrim(cPersonal) would start at line6 instead of always on line9.
How do we go about doing this ?
TIA
Pierre Richard
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only