Walter Meester
HoogkarspelNetherlands
General information
Category:
ActiveX controls in VFP
Dan,
>"regsvr32 crpe32.dll " resulted in the following error message:
>"CRPE32.DLL was loaded, but the DllRegisterServer entry point was not found.
>
>DllRegisterServer may not be exported, or a corrupt version of CRPE32.DLL may be in memory. Consider using PView to detect and remove it."
My mistake, it shouldn't be registered..., sorry for the confusion.
>"Crystal Reports Database Error: Physical database not found.
>Error Opening File.
>File could not be opened: 'resbatch1', at file location: 'c:\vfp_eis\data\resbatch.dbf'"
>
>** 'resbatch1' is the alias used in the Crystal Report to reference the DB
>** the file listed in the error message: 'c:\vfp_eis\data\resbatch.dbf', did actually exist, so it was there, it just couldn't be read.
Hmmmm. Are you working on a development machine ? Then try to reinstall CR. If your working on the client, you should re-distribute all the neccesary runtime DLLs. See the runtime.hlp helpfile in you CR directory.
Also important. Be sure that the needed DBF is not exclusively in use by VFP.
>Imediately following that error message, FoxPro displayed:
>
>"Program Error
>OLE IDispatch exception code 20532 from CPEAUT32: Cannot find database DLL..."
>
>I would assume I need an additional DLL (depending on the database type my Crystal Report is reading data from). I think there was a section on this in the Seagate Help files, but I don't remember seeing a driver for the FoxPro dbf's...
The file P2BXBSE.DLL is needed. See runtime.hlp for more info
Walter,
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only