General information
Category:
Reports & Report designer
Visual FoxPro "burns" the printer driver info into the FRX. If you USE the FRX, just as you would a table, you will see two memo fields in the first record. They are called TAG and TAG2. After you have built the report, open the FRX as a table, and blank out those two memos.
Important... Every time you go into the designer, those memos will be re-populated. Be sure to blank out those memo fields.
Good luck..
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only