General information
Category:
Forms & Form designer
The code only takes a second or two and the interval is set to thirty seconds. The code is doing some DDE calls to read some registers on a PLC if that makes any difference.
THanks
>Only if the code in the timer event takes longer (or about the same) than the timer interval.
>
>Vlad
>
>>Should I do a Timer.Enabled = .F. at the start of the code and a Timer.Enabled = .T. on the way out of my code to start another interval??
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only