General information
Category:
Coding, syntax & commands
>The click event of my save command button calls a procedure. The procedure updates some values in a cursor. Control then returns to the click event. The commands following the procedure appear to be using the previous cursor values, not the values the procedure updated. How do I tell it to use the updated cursor? The cursor is based on a remote view.
>
>Jeff Rusch
>UW-Madison
Try to close the cursor, when u call the procedure.
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only