General information
Category:
Reports & Report designer
>>>>I hope I can explain this good. It's kinda complicated.
>>>>
>>>>I have these report variables:
>>>
>>>Make sure that Imargin is always Imargin and never Lmargin. Lmargin is also a numeric value. Look at the order that the variables are defined.
>>>
>>>Good luck!
>>
>>It's the same calculation, so the variable names can't change. Why would the order affect it?
>>
>>Thanks,
>>
>>Michelle
>
>Yeah, but if Lmargin happens to have a value close to Imargin, you couldn't tell.
>
>The order will control the value at the time of evaluation. It might be using the value from the line above (which, if I remember correctly was close to the line where it was right.)
It's an "i". I double-checked. The variables are declared in the order that I listed them. I don't understand why it would be using a value from the line above? I can't see a situation where you would want it to start using values from a different group on random lines.
Thanks,
Michelle
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only