General information
Category:
Databases,Tables, Views, Indexing and SQL syntax
>I have created an ODBC connection [Connect1] for a remote view of an Access table. Everything was working fine yesterday, but now I am getting an error: Connection Connect1 is busy. If you select ignore, it goes ahead and completes everything just fine. Instead of ignoring, you can go step by step using the debugger and you don't get an error message. Any ideas?
>
>Thanks,
>Doug
Are you sharing the connection with more than one view? If so, make sure you aren't using progressive fetch with either one.
BOb
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only