General information
Category:
Reports & Report designer
I USED HOTSEND AND IT WORKS FINE, EXCEPT WHEN IT INSTALLS ITSELF IT WILL SET ITSELF AS A PRINTER WITH THE OUTPUT PORT "LPT1", IF YOU USE THE VFP COMMAND:
SET PRINTER TO NAME "HotSend Email Attacher"
THEN DO:
REPORT FORM MYREPORT TO PRINT
YOU WILL GET A PRINT OUT BY THE PRINTER THATS ON LPT1: , NOT A eMAIL TO THE MODEM.
TO FIX THIS YOU NEED TO GO TO (START BAR),SETTINGS,PRINTERS,[SELECT HOTSEND EMAIL ATTACHER],DETAILS,ADD PORT [YOU WILL SEE THE PORT IS LPT1: CHANGE THIS TO THE COM PORT THAT YOU HAVE YOUR MODEM CONNECTED TO. NOW YOU SHOULD HAVE NO PROBLEM.
GOOD LUCK,
DON CARLOS
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only