Bill,

You should be able to hack the properties memo as long as you add the stuff at the end and make sure there is a CR/LF after each line with no blank lines.

The other thnig you could do it call up each container in the class designer and run a builder on it. You can programmatically do MODI CLASS ... NOWAIT

>This is a VFP 6.0 issue. I have about 1200 controls in a VCX that need to have their ControlSource and Alignment properties populated. I wrote a program to add these properties and their values to the VCX Properties memo field. However, this is not enough. When I compile and then open the VCX with the Class Designer, the ControlSource and Alignment properties are empty. And the values that I stored with my program are deleted.
>
>Is what I'm trying to do feasible? Or, do I have to bite the bullet and continue with the Class Designer?