General information
Category:
Coding, syntax & commands
>use data1 in 0
>? select() ** the esult is 1
>use data2 in 0
>? select() ** the esult is 1 ***** this result is 2 in the first code
Because it doesn't change the current WA. Simple as that. A USE x IN x doesn't move you to the x work area, just opens table x in x. Where is your first code you were actually moving to x before opening it there.
Does it make sense? This is a good thing, I don't want my work area jumping all over the place, especially like in a scan or something.
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only