General information
Category:
Forms & Form designer
>I have the same problem. I have grid and i will search. I have procedure to search any string in grid, but Ctrl+F to do this procedure not work. (I use other key ... Ctrl+H), ctrl+f do not go to keyPress of form.
>
>HELP!
the cause, in my case was laziness on my part. Instead of launching the project manager by typing MODI PROJ BUS or whatever, I wrote a little prog with that line in it called 'b' so that, instead, I could just type DO B. It seems that if you do that then the 'find and replace' function goes out of scope or something boringly similar.
If that is what you're doing too, the solution is simple. Stop!
If you're not guilty of that behaviour then my experience is of no help to you. Hopefully someone else might have a clue.
Good Luck
Harry
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only