Hello,
I have a FPW 2.6 application at a client site. It runs fine on all of the computers except the IBM 300 GL Personal Computers. Here, it gives me an I/O error. When I put a CD in the drive, it runs fine on the IBMs too.
I have searched the threads for this type of error and found a couple of suggested fixes. One fix was to place TMPFILES and PROGWORK in the Config.fpw and direct them to the C:\ drive on your computer, then rebuild all. I did this and it did not work. Another fix was to open the project and REPLACE ALL object WITH "", then rebuild. This did not work either.
If anyone has any other suggestions, I would appreciate it.
For further information, this is a rather large network with one site a half mile from the server and another site a mile from the server. Computersat both sites other than the IBMs can connect and run the application with no problem. Only the IBMs are giving me the above error.
The IBMs are direct from the factory PIII 450 with 32-64 megs of RAM. They have IBM network cards and appear to run fine with other networked programs.
Thanks for your suggestions.
Thanks,
TFISHER