General information
Category:
Coding, syntax & commands
>Just like you would at the run command line. Make sure to accept Params in your Main.prg or default file.
Mike, I've tested calling a simple VFP exe from FPW and it works great.
Just another few questions
1. Is it possible to send parameters back to the originating FPW app ?
2. Is there a way of telling if the VFP app is running, and if so some way of calling it from FPW.
Basically, I will be using a small program to validate codes from a lookup table and to write a record. Loading the VFP exe each time (from my FPW app) will probably be too much of an overhead and take too long .
I wonder can I somwhow , first check if the VFP exe is running, and if so send it my parameters ?
regards,
Gerard
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only