General information
Category:
Forms & Form designer
>However, I can only use the x,y coordinates of the form of it's development size. How can I make full use of the form's x,y coordinates in the maximumized mode. Is there a variable that the form multiplies by to do the maximumize operation?
I don't understand, unless you are hardcoding in the Forms initial Width and Hieght or Top and Left values. Instead use the properties. If this isn't it, can you post a little code? Anyting helps/
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only