General information
Category:
Reports & Report designer
The Report command is
REPORT FORM IEPFORM NOCONSOLE FOR cnumber = cnum RANGE 1,2 TO PRINT
This command printed all 5 pages of the report.
Stan
>>I tried the Range command, but all pages print regardless of my settings for start page and end page. Is there anything else to do to make it work?
>>Stan
>>>Use RANGE nStartPage [, nEndPage] in your REPORT FORM command.
>>>
>>>>Is there a way to selectively print pages in a Visual FoxPro report (VFP 5.0). I have a report that is usually 5 or 6 pages. If a user makes a minor change to page three, is there a way to print out just that page or perhaps 3 thru 6. I tries using while _pageno >= 3. This doesn't work. Any suggestions would be appreciated.
>>>>
>>>>Stan Symons
>
>Are you trying to do this from a REPORT PREVIEW? The RANGE clause of the REPORT command does work. Show us your REPORT command.
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only