>I am having problems using my config.fpw file. When I start, VFP runs through my config file as if it were a prg file.
>Each line in the file, I get a variable {whatever I am setting to} not found error.,ie; EXCLUSIVE=OFF.
>This has been an ongoing problem I have had. I had worked around it before by using the standard SET command syntax in the file,ie; SET EXCLUSIVE OFF. After doing this workaround, I began receiving "No Parameter Statement is Found.". Is there something I am missing?
Just as a note, I did find the problem with this... Our CNE set my FOXPROWCFG and FOXPROSWX variables in my login script to point to my local VFP directory instead of the network config file located on the network for the users. When he set the foxproswx variable, he set it as {SET DOS FOXPROSWX="c:\vfp\config.fpw"} This was being added as command line switch to run my config file as a program instead of just using it.
Précédent
Suivant
Répondre
Voir le fil de ce thread
Voir le fil de ce thread à partir de ce message seulement
Voir tous les messages de ce thread
Voir tous les messages de ce thread à partir de ce message seulement