This is probably too obvious, but it's gotten me. :) I modify code in one copy of VFP and run SBT in another. If I forget to close the code in the modify copy, I get that error when I try to debug in SBT.
To make a long story short, make sure it's not open anywhere else. :)
Michelle
>VFP is not allowing me to debug my apps. If I put a set step on, or a breakpoint in a program, it opens up the debug window (like it's supposed to). But all I get is "Source not available". I deleted the .FXP's just in case and tried it again. Same thing. I re-installed VFP. Same thing. Then I just created a new program and copied the old program's contents over and ran it that way. It worked! Once. Then I get the above error again.
>
>Any thought or comments would be GREATLY appreciated at this point. BTW, I had been using SP3 when this started and just installed SP4.
>
>Thanks!
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only