>I had a similiar problem, try totally removing the vfp software and then install the 3.0b version. > >This should correct the problem. > Sometimes you need to go in and Manually delete any files that could be left behind after removing the software. I have found cases were this was the only way I could get the new copy to work right. HTH, Tom > > > >>>>I just installed the fix for VFP 3.0 to 3.0b. When I make an application the setup.exe does not run correctly. I installed the new 3.0b over the original 3.0. I know of at least two problems. >>>> 1. On the new setup If I am running VFP it does not ask me to shut it down like the old setup did. >>>> 2. I receive Object ID37: CopyFile-like object: Bad Inf Key data value. >>>>The second Object ID?? Changes numbers and appears at least 10 times before setup is done and the application is not loaded. >>>>Thanks... >>>I just downloaded setup.exe and moved the files to the loaction in the readme file. Have same problem.. >>>The oldwzsetup.app had a date of 06-21-95 and the new has a date of 05-03-96 and when making new application the setup.exe date is 06-21-95... >>>Need some help!!!! >> >>This probably is not your problem, but FYI: I received some strange messages with the setup routine, and it turned out you cannot use > > > >an EXE created in 3.0 with the 3.0b setup wizard. It was some time ago, so I don't remember the specifics, but I thought I should share that experience with you. Good luck. >>Marcus.