General information
Category:
Reports & Report designer
Hi Steven,
Follow these steps.
1) Open up your form file as a table i.e. USE myreport.frx (where myreport is the report name)
2) Type BROWSE
3) The field OBJTYPE for the first record should have value 1. If not locate the record that has the value OBJTYPE as 1. In that record if you go into the EXPR field and press you would see an entry COPIES=1. Just change to COPIES=2
4) Close the table by issuing clear all
That's it.
>Is there a way in the Report Form command to specify the number of copies to >print when printing a report? I know that I could loop through the Report >Form command for copies but when a batch is sent to the printer it prints a >lot faster. Thanks for the help.
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only