General information
Category:
Coding, syntax & commands
>>>>>>I am trying to add a new record, I can insert the record into the table. Although, my record pointer stays on the last record, it does not move to the new record that I just inserted. The problem being that when you start to key into the controls you are making changes to another record. Any Ideas???
>>>>>
>>>>>refresh your form?
>>>>
>>>>
>>>>I am already refreshing the form. any other Ideas on why my pointer will not move to the new record. I have even tried a go bottom, after the insert.
>>>
>>>are your controls bound to the data file?
>>
>>
>>Yes, I have the ControlSource set to the field in the table.
>
>are you using append blank or insert into... append blank places you in the new record -- insert into doesn't
I have tried both, currently I am set up with the insert. I had the same results using append blank, that is why I went to the Insert. Although I will try append blank again.
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only