General information
Category:
Reports & Report designer
>Is there a simple way to convert either a report form's layout data, as held in the forms actual .frx/.frt data files produced using the visual 3.0 report designer tool, into the layout data as held in the .frx/.frt data files used by the 2.6 report designer tool?
>
>I need to be able to have reports designed originally under 3.0 also be run and "redesignable" under 2.6; say we do not have to bite the bullet and do the whole job over from scratch in 2.6.
>
>Aaaaahhh! I hope there is a way. BTW: whoever heard of "downgrading" while everyone else is busily "upgrading" :))) There are plenty of suggestions in the UT data basse for going from 2.6 to 3.0 and 5.0 but I have not found any for going the other way. Hope y'll can help.
>
>TIA. /psb.
Have u tried copy and paste ??
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only