General information
Category:
Forms & Form designer
>>Once again, thank-you ... and as they say in Hawaii ...
>>
>> Mahalo Nui Loa!
>
>Glenn,
>
>Well I am available for a couple of weeks of consulting. We don't need to do any actual work, we could just hang out on the beach and discuss VFP if you like <g>.
Jim,
Thanks again for your help and offer. It's an honor to be able to get professional tips, techniques and solutions from the FOXPRO guru! I think I'll take advantage of it ... right now!
I came straight from Foxpro 2.6 for DOS to Visual Foxpro, so I get lost at times when I try to incorportate some things into Form. In the DOS version, I was able to include procedures and functions in the "clean-up" section for the form, however, in Visual Foxpro I'm not sure where to include the actual procedures (i.e., the procedure name, codes, etc). At this point, I open a procedure file in the Load Method/(Event?) so that the command buttons and other controls on the form can call those procedures and functions. Is there a "place" where I can include these "snippets"?
Thanks,
Glenn
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only