Level Extreme platform
Subscription
Corporate profile
Products & Services
Support
Legal
Français
MoveFolders problem
Message
General information
Forum:
Visual FoxPro
Category:
Coding, syntax & commands
Miscellaneous
Thread ID:
00446793
Message ID:
00447656
Views:
19
>>>>>Nadya,
>>>>>
>>>>>As I explained in the Dec. issue of the newsletter, unfortunately, Ed did not have sufficient time to do the peer review on this article as thoroughly as he normally would have. In haste, because the deadline for the article was approaching, I sent my original to Carl without having given it as close attention as I should have. Therefore, the error is completely mine. Cetin is correct. It is MoveFile() and the second parameter cannot contain wildcards.
>>>>>
>>>>>I'll make the corrections and forward them to VFUG as soon as possible.
>>>>>
>>>>>Thanks for the heads up,
>>>>
>>>> Thanks, George. This is what I wanted to hear. Check also the parameter you passed in example of GetSpecialFolder method. It should be 2, not 3, as in the article.
>>>
>>>Nadya,
>>>
>>>This problem was previously noted (in the December on-line edition) and the values corrected in the on-line edition of the November edition's article.
>>
>>George,
>>
>>See these lines:
>>
>>are the values to pass. For example, to get the Windows temporary folder:
>
>>loFolder = oFSO.GetSpecialFolder(3)

>
>I'll ask Carl to fix this two. Directly above it (and this was cut from the newsletter):
>
>"0 – The Windows Folder
>1 – The Windows/System Folder
>2 – The Windows temporary folder"
>
>>Also there is no note in December issue (your article) about haste, etc. I checked on several machines to be sure, my local machine doesn't cashe these pages.
>
>You're not looking hard enough. Check "Oops...I did it again..." - Errata/Member feedback.

Thanks, George. Now I see.
If it's not broken, fix it until it is.


My Blog
Previous
Reply
Map
View

Click here to load this message in the networking platform