General information
Category:
Reports & Report designer
Hello Emiliano
I can usually just stretch the height of the footer so that my Totals appear nearer the middle of the page if required.
You can create variables and then place them where you like in your newly expanded footer. Use these variables to store the results of your other calculations.
If all else fails you can abandon using the a Report Form and instead use the SET PRINT commands with @SAY to get much finer control. Its a bit laborious but it gets you there in the end.
You could also consider Crystal Reports which works well with VFP.
Good Luck
>Hi. I have to print a report wich is an invoice. But i have a problem with the last part of the paper, all the items data is shown in the detail section, but i have to print the totals, discounts, etc on an exact part of the paper (near the end), but not in the position thar the report manager sets as group footer. As additional info: i have a data group and have to make the calculations of that data i can't place in the correct place.
>
>Thanks
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only