General information
Category:
Reports & Report designer
>>>>>Hi everybody,
>>>>>
>>>>>I'm trying one more time (another thread) for the same problem. I'm afraid, there is no simple solution for my problem and, perhaps, there is no solution at all :(
>>>>>
>>>>>Ok, I have 3 columns report. I don't want to split Group Header and Detail Band, e.g. if Group Header would be print at the bottom of the page, I want it to start new column (or new page) instead. How can I make it work?
>>>>>
>>>>>How can I search MSDN if the problem was already discussed?
>>>>>
>>>>>Thanks in advance.
>>>>
>>>>You can set the Start Group on new page when less than propertie when you are in the grouping properties. (Measered in inches)
>>>
>>>Ko,
>>>
>>>I tried this option. I set 0.05, 0.1, 1.00, 2.00, 3.00 etc. with no effect. Do I need to keep trying? :)
>>
>>For me that works.
>>Of course i had not data on the end of the page, but setting the value to 10.0 helped me putting the data to the next column, not to the next page.
>>But 10 inch = 28 cm ???
>>So i begin wondering if it is really measured in inches.
>
>Seems like 10 did the trick! :) Thanks a lot to everyone. Hopefully, it's not an eye blink :)
Well, there you go. I was actually looking into padding spaces onto the end of a field to force the header to the top of the column, but if this works, what the hay!
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only