>>I realize that there *was* a problem with the 'prompt' command when sending a report to the printer. According to MS this was resolved in version 5.0a. I am now running 5.0a and have recompiled my apps but end up with the same problem. Do I need to do something else in order for this 'feature' to go away?
>>
>>George
>
>I'm not sure which of the following dll files holds the fix, but you have to copy them to every computer using the applications. (Put them in the windows/system folder.
>1. VFP500.dll
>2. FFP5env.dll
>3. VFPodbc.dll
>4. VPPole50.dll
>You must have version 5.0a installed to get these new files. I did not have to unistall 5.0 before installing 5.0a. It just wrote over the top of the old files. I then went around the office and copied the 4 files listed above to each computer, and now everything runs smooth.

Odd. I did a complete uninstall and then a full install once again. This seemed to resolve the problem. I am assuming that if I compile my applications and actually run the full 'setup' routine for the application, the 'offending files' should be replaced...if not I will definitely use this method.

Thanks