Do you see anything in this code that would cause a blank page to print after the report is done printing? I always get a blank page after the report is done printing. I also think it might be a page length issue, but I only print down to 3/4 of an inch from the bottom edge of the page. 3/4 inch bottom margin minimum. Any ideas? Thanks!
SET PRINTER TO LPT1:
SET PRINTER ON
SET NULLDISPLAY TO ""
SET ANSI ON
SELECT * FROM aed_info ;
WHERE ALLT(aed_info.name1) = ALLT(THISFORM.t_name1.Value) AND ;
ALLT(aed_info.unitid) = ALLT(THISFORM.cbo_unitid.DisplayValue) ;
INTO CURSOR rpt
SET ANSI OFF
REPORT FORM \aed\aedlocdt.frx
SET PRINT OFF
SET PRINTER TO
CLEAR
THISFORM.Refresh
Steve Kramer
Kramer & Kramer Design
"Home of Go Cartoons"
Web Site:
www.stephenkramer.comWould you believe Far Side Lite?
More than 270 original cartoons.