General information
Category:
Coding, syntax & commands
Title:
Set reprocess command
Hi all:This should be basic, but I cant seem to figure this out. I have the following situation:
1.) I open VF6, open table "mytable" exclusive
2.) I open another VFP6 and set reprocess to 5*60 seconds && 5 minutes
3.) I try to open table "mytable"
4.) VFP6 immediately responds with "File access is denied"
I was expecting VFP to attempt to open the table for 5 minutes before erroring out. This occurs if I set reprocess to -1, -2, automatic, etc...
What am I doing wrong here?
Thanks!
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only