General information
Category:
Installation, Setup and Configuration
Ransome, are you using the setup wizard to attach an icon to the exe? I find that whenever I do that, the .inf file gets set up badly. For some reason, it creates the icon line as referring to disk 0 instead of disk 1. Then if I don't go into the .inf file and correct it manually, I get oddball error messages when I try to install.
I haven't done that in a long time, so I'm not sure if it was an error 279, but it was some untraceable setup error number in the setup.
Alan
>Dear all,
>
>My computer configuration is listed in the following:
>
>Cyrix 166+
>64MB RAM
>Windows 95 OSR-2
>Visual Foxpro 6.0 with SP5
>
>In using the setup wizard, I can sucessfully produce setup disks. (I can't do it in the past before upgrading Service Pack)
>
>However, I cannot distribute the disks. when I try to install my project in other machine (even on my own one). I fail to continue the setup process from which I am reported a setup error # 279.
>
>Somebody told me that it may be due to the fact that in Windows 95, some vital DLL is absent, or otherwise, some curcial explanations?
>
>
>
>With regards,
>
>Ransome
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only