>It is said in help , that _plineno,_poffset etc are included for backcompatibility.
>The test in report preview shows, that they return nothing.
>Is it any choice to get pixel (or any other units) coordinates of report of each element
>in report preview?
>Best wishes, thanks in advance, Vladimir.
I don't know if this will be any use to you... but
If you open the report as a table then you can see the Vpos & Hpos of each control in 1/10000ths of an inch/cm depending on report settings
but this is only the position in design mode.
HTH
Will Jones