General information
Category:
Reports & Report designer
>>Yes, the setting is in inches. I have for e.g : 50 records and I want to make one page = 30 records so when the pointer goes to record no. 31, it will go to the next page. For your information I have a page footer.
>>
>>Anyway, could you give me a guess for how many inches should I fill in the "Start group on new page when less than".
>>
>
>Not really; it's going to depend on the height of your detail band and page and group footers; you're going to have to play around with the value. Why not create an artificial grouping based on a report variable that resets it's value on the start of a new page, and make the variable increment by 1 for each detail line, with a 0 height group header/footer and force the page break when the count exceeds 30. This obviously assumes already that you have an existing data grouping that forces a new page every time the data group changes already, so this is simply a further group layer inside the existing grouping.
>
>The height of the detail band obviously affects position on the page; the font height and spacing both factor into this decision. You're going to have to test to get it right.
Hi Ed,
I did what you've told me, using another grouping (with expression ncount=30) inside the first one but why it didn't print all, for e.g if I have 4 pages, the 1st page was printed, the second was not, the third printed, and the last was not. Did I miss something ?
regards,
Budianto M.
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only