>I am trying to maintain some code that was written in FP 2.6 for Macintosh. The problem is that whenever a single page is printed the printer prints out the page plus 2 blank pages. Where can I found the option for page length or page eject? Also, on an addtition I just made -
I never used FP for Mac, but I assume it is the same as for other platforms: open the report file (MODIFY REPORT) and look in the Report menu. I think there's a Page layout option.
Also, take a look to _PLENGTH system variable in the Help.
>I SET DEVICE TO PRINTER and then several @ says and then SET DEVICE TO SCREEN. THe problem is that it won't print out the page until the user exits the program. If I follow the above with EJECT, I get a warning that this will cancel the previous print job, do I want to continue. If I say yes it prints the page, plus 2 blank pages. If I say no, it just gives me the same message again until I say yes. Any help would be greatly appreciated.
First, this technique is old and not so good. Use the report generator instead. Also, try SET PRINTER TO instead of EJECT.
Vlad
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only