>>>I keep getting a GPF fault when doing a tableupdate from my form. When I do it from the command line, it works fine. I have reindexed and packed both my DBF and SCX files. Has anyone seen anything like this or know what might be causing it? Am I doomed to start my formset over again?
>>
>>Hi Sean,
>>If you are using a grid in your form, and the grid RecordSource
>>is a table that is open in an work area greater than 255, you
>>will have a general protection fault. Microsoft is still
>>researching this problem. That can happen if you use SELECT(1)
>>to get an unused work area.
>>
>>Hope this help.
>
>Luis! Hello Gator in crime (busting!)
>
>Whoah! Glad I use Select(0)! I never could see see any sense in starting at 255... (s)
>
>Thanks
>Tom
You are welcome. I found that the hard way. I used to use
SELECT(1) since FoxPro 2.0 , and it worked fine until,
you know, "The Grid".