Jay Johengen
Altamahaw-Ossipee, North Carolina, United States
General information
Category:
Reports & Report designer
>Hi,
> I am using MS Graph to generate my graph report. I will set the the series color, pattern and etc. It works fine. It show the graph as what i wish.
> However, when I print it out using laser printer, the pattern which I pre-set is missing. My printed graph just show it as grey color.
> Any ideas?
>
>thank you
John,
I had this happen a few years ago and the problem was that the printer did not support the graphical fill patterns. If that's not it, check your printer setup dialog and make sure that it's in the Fine mode and any graphics options are checked.
Regards, Renoir
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only