General information
Category:
Reports & Report designer
Very messy for sure. These are printed forms. There are many lines (not data but drawn lines), very small print, tons of verbage, little boxes that are checked from data, on and on. With this not being a standard report with a header and detail where the detail section is virtually blank except for the report data, I don't think PrintWhen is going to work here. You'd never be able to change the definition without having to try and wade through all the rest of the mess. Thanks for the suggestion though!!!
Steve
>Hi!
>
>Make it as a single layout by just a copying of all controls from second layout to first layout. However, for all controls on the first page put the PrintWhen... condtition to print them only on the first page, for controls from second layout put a condition to print only on the second page. Quite messy, but it will print in a single pass, so I guess it could be done that way.
>
>HTH.
>
>>Anyone ever get a report to print duplex with two different report definitions?
>>Page 1 has a definition and I'd love to get the backside to print in one pass also. Currently, I have two report definitions, one for the front side and one for the back. Users have to print the front from the tray and then flip over the paper and load to the manual tray. Would love to end this.
>>
>>Thanks,
>>Steve
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only