General information
Category:
ActiveX controls in VFP
>I have a form that contains a Page Frame. Page1 contains another page frame. On page 3 of the second or internal page frame is DBI Techs List Box (Active X Control).
>
>If the user clicks on Page 1 of the form Page Frame and then Clicks on Page 3 of the internal Page Frame and then makes a menu choice where I programtically switch the form page frame to say page 2. The DBI Tech List box overlays controls on the newly shown form Page frame.
>
>If the user changes themselves to page 2 of the the form page frame I do not have the problem. Only when I do this programaticaly
>
>I have had other refresh problems that were different but was able to take care of those problems by doing a SETFOCUS() on the ActiveX Control. This did not work here. I tried setting the ZORDER(1) on the ActiveX Control prior to changing the form level page frame. This did not work.
>
>Looking for some suggestions. Thanks in advance
I use a lot of the Dbi controls, but haven't seen this problem. How about trying to put the Dbi control in a container?
Are you using the ctlist control?
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only