General information
Category:
Reports & Report designer
This report prints a mailing address and the letter is then stuffed into a windowed envelope. Going landscape is not an option.
Brenda
>
>In the Report Designer, can you go to File/Page Setup and change it to >landscape? If that is acceptable, the open the report table and delete the >DRIVER, DEVICE and OUTPUT lines from the EXPR field in the report.FRX table. >Then clear out the TAG and TAG2 fields.
>>
>I have a report which contains a reportfield that is appropximately 200 pixels in length and there is no room to make it any wider. My client wants to fit in four fields, subdivsn c(25), phase_unit c(4), block c(4), and lot c(8) in that order. Well of course if all the characters are non-blank, they will not all fit. But if it can not all fit they want the full lot, block, and phase_unit and trim the subdivsn.
>
>I am at a lose. I have Arial point 8, but how would I know how many of their text will fit in a 200 pixel field, and how would i trim the first field to make the rest fit. Any ideas?
>
>The current expression in the reportfield is the following but it is not working as desired.
>
>IIF(EMPTY(subdivsn),"*",ALLTRIM(subdivsn) + ' ' + IIF(EMPTY(phase_unit),"*",ALLTRIM(phase_unit)) + ' ' +
>IIF(EMPTY(block),"*",ALLTRIM(block)) + ' ' +
>IIF(EMPTY(lot),"*",ALLTRIM(lot))
>
>
>Thanks
>
>Brenda
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only