General information
Category:
Forms & Form designer
>Hello Maria,
>By any chance are you opening your table in an area greater than
>255, if this is the case you will have a GPF for sure, that is
>a known problem in VFP, you can not populate a grid with a table
>that is open in a workarea greater than 255. That happens when you
>use SELECT(1) to have an empty workarea or USE MyTableName in 1.
>Hope this helps.
I can't believe it, but that was it! I was going nuts trying to figure this out and I wasn't pleased with my work around. Where is this documented?
Thanks so much.
Maria
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only