>Today I tried to modify a project (FPW 2.6) using a PC Anywhere connection. I get an error box that says "I/O Operation Failure".
>
>I can open the .pjx file as a table and the file is not marked as read only.
>
>Any Thoughts?
It sounds like a problem I have, when a project is referencing a disk that the machine I currently using, doesn't have (typically F:\). I solved this by making sure I have an F: drive, or whatever the particular drive is.
I haven't had much luck getting rid of this other ways. I tried opening the project as a file, and getting rid of all references to other drives, but must have missed something somewhere...
Anyway, easiest way I found was to connect up to some other machine, and map a drive as F:
Good luck.
EMail: danielj@ryte-byte.com
"If I'm paddling so hard, how come I'm going backwards?" - Pinocchio (while the whale was swallowing him...)